Repeats and endings
Set the order in which bars are played without copying the music.
Repeat a section
- Select a note in the first bar of the section.
- Click the start-repeat button ๐ in the Repeats group.
- Select a note in the section's last bar and click the end-repeat button ๐.
- Start playback before the section and listen to its route.
You can select a passage first: start-repeat uses its first bar and end-repeat uses its last.
The end-repeat button cycles through two, three, and four total plays, then removes the end repeat. The start-repeat button toggles its marking on or off.
Add first and second endings
- Select the bar for the first ending, or a passage covering its bars, and click 1..
- Put the end-repeat marking at the end of the first ending.
- Select the following bar or passage for the second ending and click 2..
- Listen from before the repeat to check the first and second passes.
Select the same span and click its ending number again to remove it. Adding an ending can replace overlapping ending brackets.
Use D.C., D.S., Fine, and Coda
Select a bar and use Jumps to add the marking. Segno and Coda signs go at a bar's start; navigation instructions go at its end.
D.C. returns to the beginning; D.S. returns to the segno. Use the matching Fine or Coda instructions and signs for the route you intend. In the current editor, repeats are not taken again after a D.C. or D.S. jump, and the last ending is used.
Playback, MIDI export, and MusicXML export follow repeat and jump markings. Check a complete playback before sharing a score with a complex route.
