Chords and four voices
Put pitches on one stem, or write independent rhythms on the same staff.
Build a notated chord
- Enter or select the chord's bottom note.
- Hold Shift and type the letter of the next pitch.
- Continue adding pitches with Shift and letters. Each is added above the chord's current top pitch.
For an original practice chord, enter C, then press Shift+E and Shift+G. The pitches share one duration. You can also Shift+click piano keys to add pitches.
Pitch movement and accidental commands affect the selected chord as a whole. For chord names above the staff, use chord symbols.
Write up to four voices
- Enter the upper line in voice 1.
- Select the note or rest at the beat where the lower line should begin.
- Click 2 in the Voice group, or press Alt+2.
- Choose a duration and enter the lower line. Voice 2 uses downward stems and is shown in green while editing.
- Press Alt+1 to return to voice 1 at the same beat.
Use the Voice 1–4 buttons or Alt+1 through Alt+4 to choose any of the four independent rhythmic lines on a staff. Voices 1 and 3 have upward stems; voices 2 and 4 have downward stems. A chord is several pitches sharing one event; another voice is a separate rhythmic line.
To remove voice 2 from a bar, clear its music to rests, then press Delete on an unmarked rest in that empty voice-2 bar.
Add harmony and check the part-writing
Harmony… is in the Score group on the Musician plan. For a hymn written in parts, open it and choose Where: The whole score or The selected passage. Set Chords change to On any beat, At most twice a bar, or Once a bar. Choose whether to Replace the chord symbols already there, then click Add chord symbols.
The editor works the chords out from the notes in all the parts and writes them above the top staff. Check the result and edit any symbol you would play differently. It can write slash chords such as F/A and uses the key's own sharps or flats. One Undo removes the generated chords.
In the same dialog, click Check under Check the part-writing. The list reports parallel 5ths and octaves between any two parts. Click an item to jump to that note and inspect the passage.
Write notes across staves
- In piano, organ, or choir notation, select a note or passage.
- Press Ctrl+Shift+↑ to write it on the staff above, or Ctrl+Shift+↓ for the staff below. The Cross staff buttons do the same.
- Repeat the same command to return the notes to their own staff.
The notes retain their pitches, rhythm, and instrument ownership. Beams can join notes across the staves. Crossing is available between eligible staves of an instrument or choir; it does not move music into an unrelated instrument.
Put lyrics under the melody
Switch to voice 1 before entering lyrics. Mizmor Studio attaches lyrics to voice 1. See Lyrics and verses.
